Viking - Render and 3D Print

Viking 3D Print Project. I sculpted and sliced up the model in Zbrush. The separated pieces were assembled in Chitubox. Drainage holes were punched into the base in Chitubox. This allows you to hollow out the base and conserve on resin. The printer I used is a Anycubic Photon Mono M5s resin printer. I'm surprised that some of the smaller details printed like the chainmail and partially the design work on the helmet and pouches.

Just for fun I mapped a clay material onto the 3D mesh in Marmoset for some renders. Also, The base seen in the Marmoset renders is a new base I made after the print was created. Eventually I'll print him with the new base. One thing I learned after going through the whole process is that any thin pieces are fragile. Next time I'll thicken up the thinner bits. Overall, I had fun working on it.